User Manual

34
– Output volume: If the sound from the speaker is too low or high it is possible to adjust
the output gain for the active speaker attached to the network camera.
– Mute: User can disable the output audio transmission by checking the box.
When the settings are complete, click Save button to save the settings, or click Reset button to clear
all of the information you entered without saving it.
3.6.4 Event
1) Event In
∇ On Boot
This is used to trigger an event every time the network camera is started.
Select “Enable on boot” to activate the On Boot event.
Enter the Dwell time the event lasts from the point of detection, 1-180 seconds.
When the settings are complete, click Save button to save the settings, or click Reset button to clear
all of the information you entered without saving it.