User Manual

72
– Priority: When the maximum bandwidth is exceeded, prioritize the data to be reduced.
When the settings are complete, click Save button to save the settings, or click Reset button to clear all
of the information you entered without saving it.
∇ NAT (Port Mapping)
• Wire NAT traversal Settings
– Enable: Check this box to enable NAT traversal. When enabled, the network camera
attempts to configure port mapping in a NAT router on your network, using UPnP. Note
that UPnP must be enabled in the network camera (see System > Network > UPnP).
· Automatic setting: When selected, the network camera automatically searches for
NAT routers on your network.
· Manual setting: Select this option to manually select a NAT router and enter
the external port number for the router in the field provided.
NOTES:
• If you attempt to manually enter a port that is already in use, an alert message will be
displayed.
• When the port is selected automatically it is displayed in this field. To change this enter a new
port number and click Save.
• For NAT (port mapping) to work, this must be supported by the broadband router.
• The broadband router has many different names: “NAT router,” “Network router,” “Inter- net
Gateway,” “Broadband sharing device” or ”Home firewall,” but the essential purpose of the
device is the same.
When the settings are complete, click Save button to save the settings, or click Reset button to clear
all of the information you entered without saving it.