User Manual

76
6) Maintenance
• Maintenance:
– Restart: The unit is restarted without changing any of the settings. Use this method
if the unit is not behaving as expected.
– Reset: The unit is restarted and most current settings are reset to factory default
values. The settings that are not affected are:
· the boot protocol (DHCP or static)
· the static IP address
· the default router
· the subnet mask
· the system time
– Default: The Default button should be used with caution. Pressing this will return all of
the network camera’s settings to the factory default values (including the IP address).
• Upgrade: Upgrade your camera by importing an upgrade file and pressing the Up- grade
button. During the upgrade, do not turn off the power of the network camera. Wait at least
five minutes and then try to access the camera again.
• Backup: Save the setting values that users have entered to the network camera to a user
PC.
• Restore: Import and apply a setting value previously saved to a user PC.
NOTE: Backup and Restore can only be used on the same unit running the same firmware. This
feature is not intended for multi-configurations or for firmware upgrades.