Quick Setup Guide

Quick Guide
Error! Use the Home tab to apply 제목 1 to the
text that you want to appear here.
4
2. Installation
This chapter describes the way to install NVR.
When installing a device, connect rear of the device with each port on the basis of below connection map.
Figure 2-1 Connection map
The device starts first like below sequences:
1
Installing HDD
2
Connecting with an exterior device
3
Starting a system
4
Setting a quick setup
Installing HDD 2.1
How to install HDD in the device:
Attention

Withdraw the mains plug before installing HDD to reduce the risk of injury or
electrical shock, or device malfunction.

Make sure to check the compatibility of HDD with the device.
1
Always switch off and unplug the unit.
2
Unscrew with a screw driver (+) and open the unit cover.
3
Install HDD in the bottom case.
4
Connect a data cable and power cable with HDD.
5
Close the cover and tighten screws.