User Guide

ManualsBrandsAube Technologies ManualsOtherTH106

TH106 400-106-001-D 12/8/05 1/3

This programmable thermostat can be used to control an electric

heating system such as an electric baseboard heater, a radiant ceil-

ing, a radiant floor, a convector, etc.

The thermostat cannot be used under the following conditions:

• The resistive load is greater than 16.7 A

• The resistive load is less than 2 A

• The system is driven by a contactor or relay (inductive load)

• The system is a central heating system

SUPPLIED PARTS:

• One (1) thermostat

• Two (2) 6-32 screws

• Two (2) solderless connectors

TURN OFF POWER TO THE HEATING SYSTEM AT THE MAIN

POWER PANEL TO AVOID ELECTRICAL SHOCK.

THE INSTALLATION MUST BE PERFORMED BY AN ELECTRI-

CIAN.

 All cables and connections must conform to the local electrical

code.

 Special CO/ALR solderless connectors must be used when con-

necting with aluminum conductors.

 Install the thermostat onto an electrical box.

 Install the thermostat about 5 feet high, on an inside wall facing

the heater.

 Avoid locations where there are air drafts (such as the top of a

staircase or an air outlet), dead air spots (such as behind a

door), or direct sunlight.

 Do not install the thermostat on a wall that conceals chimney or

stove pipes.

 The thermostat wires are not polarized; either wire can be con-

nected to the load or to the power supply.

NOTE: Always keep the thermostat's vents clean and unobstructed.

o Connect the thermostat wires to the line wires and to the load

wires using solderless connectors for copper wires.

p Push any excess wire back into the electrical box.

NOTE: If necessary, before re-installing the front component, config-

ure the thermostat (see section 3).

q Return power to heating system.

Description

Installation

Select the

operating mode

Set the time

Time and day

Temperature

Operating

mode icons

Skip a period

Program the

schedule

Temperature

preset icons

Temperature

adjustment

buttons

Temperature

preset buttons

Heating power

indicator

Periods

Appears when the

setpoint is displayed

Set the day

2-wire installation

4-wire installation

TH106

User Guide

Programmable Thermostat

Summary of content (3 pages)

PAGE 1
TH106 User Guide Programmable Thermostat NOTE: Always keep the thermostat's vents clean and unobstructed. Temperature preset buttons n Appears when the setpoint is displayed Time and day Temperature Set the day Set the time Operating mode icons Program the schedule Temperature preset icons Skip a period Heating power indicator Select the operating mode o Periods Connect the thermostat wires to the line wires and to the load wires using solderless connectors for copper wires.
PAGE 2
p 3. Configuration The configuration switches are on the back of the thermostat. The factory settings are indicated by the gray cells in the following table. SW1 SW2 SW3 SW4 a Early Start Temperature / time format b Cycle length Not used c s Off On °C / 24-hour °F / 12-hour 15 seconds - 15 minutes - a. Early Start can be used in Automatic mode only.
PAGE 3
r Press Mode to exit the programming mode. NOTE: If no button is pressed for 60 seconds, the thermostat will automatically exit the programming mode. u 8. Power Outage During a power outage, the settings are stored in memory. However, only the thermostat’s clock must be re-adjusted if the power failure lasts more than 2 hours. When power comes back, the thermostat will return to the operating mode that was active prior to the power failure. v 9. Troubleshooting PROBLEM Thermostat is hot.