Installation manual

7
Step 2: Make the connections
After the wall plate is installed, the connections can be made. The Ateo speaker can
be connected in Low Impedance (8 Ohm) or High Impedance (100 V) Systems. For use
in High Impedance (100 V) systems, different power taps are available.
The wires coming from the amplifier have to be connected to the corresponding ter-
minals of the special 6-pin Terminal block connector on the wall plate. The common
(‘COM’ or ‘-’) output of the amplifier should always be connected to the ‘C’ terminal
of the connector, while the positive (‘Sig’ or ‘+’) should be connected to one of the
other terminals, depending of the power or impedance.
Depending whether the speaker will be used in 8 Ohm or 100 Volt applications, a
jumper on the rear side of the loudspeaker has to be moved. When the speaker will be
used in 8 Ohm applications, the jumper should be placed in left position, while using
in 100 Volt applications, the jumper should be placed in the right position.
Mind the polarity markings when wiring the loudspeaker cables.
8 Ω C 24 W 12 W 6 W 3 W
ATEO 4
Clevermount™
12070304800001
12070288900001
Designed in Belgium, Made in China
100 V
8 Ω
100 V
8 Ω
In most cases, the speaker cable will be provided through the wall, making the cable
completely invisible from outer side. In some cases, the cable should be fed from outer
side. For this purpose, a spot (marked in RED) with thinner material is provided at the
bottom side, which can be removed using a plier for feeding the cable into the circular
bracket.