Owner's Manual

The tip type used with Euclid in-ear headphones significantly affects the sound. The correct fit delivers greater comfort and isolation, better bass response, and a more accurate
tonal balance. Since everyone’s ears are different, Audeze supplies multiple types and sizes to choose from. To find the best fit for your ear canal begin with the smallest tip and
work up in size until you find a comfortable fit with a good seal that keeps the headphones in your ears as your head moves normally.!
To change eartips, simply pull the installed tip straight off, then push its replacement straight on the eartube until it snaps into place over the tube’s ridge.
To insert the Euclid earpiece into your ear canal, position the earpiece with the A logo slightly sideways, and press inward gently while rotating it backwards until the logo is
right-side up and the earpiece rests in the bowl of your ear. Loop the cable over the top and back of your ear.
You can see a video on how to get the best fit here: https://www.youtube.com/watch?v=CEt3HhkvzZc !
If you have further questions or need assistance, please visit the Audeze Customer Service Center or email [e-mail]
Ear Tip Selection and Fit
3
Care and Fit
Always store your Euclid headphones in their protective case when not in use
Keep the case closed and store in a dry environment
Avoid storing in extreme heat, cold or humidity
Avoid exposure to liquids or harsh chemicals
Regular maintenance is not required, other than cleaning the ear tips, but an occasional wipe with a clean, dry, lint-free cloth is recommended. For best results when cleaning
eartips, remove them from the headphones and wash in warm soapy water, then rinse thoroughly in cool water and dry with a lint-free cloth.
Never pull on the cable to disconnect the Euclid headphones from your music player. Hold the plug at the end of the cable and pull to disconnect.
Please keep the Serial Number card in a safe place, it will be required for any service requests.
Style
In-ear, Closed-back
Transducer Type
Planar Magnetic
Magnetic Structure
Fluxor™ Magnet Array
Phase Management
Fazor™
Magnet Type
Neodymium N50
Diaphragm Type
Ultra-thin Uniforce™
Transducer Size
18mm
Maximum SPL
>120dB
Frequency Response
10Hz - 50kHz
THD
<0.1% @ 100 dB SPL
Sensitivity
105dB/1mW (at drum reference point)
Impedance
12 ohms
Max Power Handling
500mW
Min. Recommended Power
> 50mW
Wired Connection
Braided MMCX
Weight
15g/pair without cable
Sound Port Diameter
5mm
Specifications