Service Manual

3. Install the B2 clutch apply plate, as shown in
Figure 168, with the rounded edge facing up.
4. Install B2 clutch pack beginning with a friction
plate onto the apply plate and alternating with a
steel plate, as shown in Figure 168, until you
have installed the proper quantity, as quantity
may vary.
Note: All friction plates should be soaked in
proper fluid for 30 minutes before installing.
5. Install the B2 clutch backing plate on top of the
last friction, as shown in Figure 168, with the
rounded edge facing the friction.
Note: Notice the number stamped on top side
of backing plate, which is an indicator that it
is selective, but no selectives available as yet.
6. Install the B2 clutch backing plate snap ring, as
shown in Figure 168, with snap ring opening
toward the transfer bearing race.
Note: This snap ring is .064" in thickness.
7. Apply air pressure to the B2 clutch circuit, as
shown in Figure 169, to test the integrity and this
will also move the snap ring to top of the snap
ring groove in case, to prepare for measurement
of B2 clutch clearance.
101
Copyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
2
475
476
479
ROUNDED EDGE
FACING UP
ROUNDED EDGE
FACING DOWN
478
477
475 B2 CLUTCH BACKING PLATE SNAP RING (.064" THICKNESS).
476 B2 CLUTCH BACKING PLATE, STAMP "2", 3.6 MM (.142") THICK.
477 B2 CLUTCH FRICTION PLATES (QUANTITY MAY VARY).
478 B2 CLUTCH STEEL PLATES, 1.8 MM (.071") (QTY MAY VARY).
479 B2 CLUTCH APPLY PLATE, 3.0 MM (.119") THICK.
Continued on Page 102
Figure 168 Figure 169
ID STAMP
Copyright © 2010 ATSG
EA
D
I
A
M .
N
U S
.
B2 CASE PASSAGE
TRANSAXLE FINAL ASSEMBLY (CONT'D)
WWW.ALL-TRANS.BY