Service Manual

104
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
15. Install the parking pawl into the slot in transaxle
case, as shown in Figure 174 and 175.
16. Install the parking pawl pivot pin through access
hole in rear of case, as shown in Figure 176,
using a small magnet.
17. Install new "O" ring onto parking pawl pivot pin
case plug, as shown in Figure 176.
18. Install the parking pawl pivot pin case plug and
torque to 14 N·m (10 ft.lb.), using a 55 Torx bit.
19. Install the park rod roller and pin assembly into
case bore, as shown in Figure 174.
20. Install the inside detent spring (if removed), as
shown in Figure 176.
21. Torque the inside detent spring retaining bolt to
14 N·m (10 ft.lb.), using a 30 Torx bit.
22. Install the park pawl anti-rattle pivot pin and
spring, as shown in Figure 174.
Note: Parking pawl anti-rattle spring gets
hooked on bottom side of the parking pawl, as
shown in Figure 175.
23. Install the park rod guide and park pawl return
spring assembly, as shown in Figure 175 & 176.
Note: Parking pawl return spring hooks in the
hole in parking pawl, as shown in Figure 175.
24. Torque park rod guide bolts to 14 N·m (10 ft.lb.).
Note: Do Not install the manual shaft yet.
25. Now install the last center support retaining bolt,
as shown in Figure 172, and torque all six bolts
to 22 N·m (16 ft.lb.), using a 50 Torx bit.
Note: Notice that the center support bolts are
equipped with locking tab washers that must
have the tabs bent up to lock the bolts in place.
TRANSAXLE FINAL ASSEMBLY (CONT'D)
Continued on Page 106
Figure 174
Copyright © 2010 ATSG
7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
146
147
148
149
146 PARK ROD ROLLER AND PIN ASSEMBLY.
147 PARK PAWL ANTI-RATTLE SPRING PIVOT PIN.
148 PARK PAWL ANTI-RATTLE SPRING.
149 PARK PAWL.
7
PARK ROD
GUIDE
ANTI-RATTLE
SPRING
RETURN
SPRING
INSIDE
DETENT
SPRING
Figure 175
WWW.ALL-TRANS.BY