Service Manual

7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
109
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
Figure 182
Copyright © 2010 ATSG Copyright © 2010 ATSG
7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
3 4 51 2
S
t
t
a
r
t r
e
9
8
0
TRANSAXLE FINAL ASSEMBLY (CONT'D)
41. Measure the distance from case pump surface to
the washer surface on the K3 clutch housing, as
shown in Figure 182, using a straight edge and
ruler, or a depth micrometer.
Note: This measurement should match the
measurement taken on disassembly to ensure
that K3 clutch housing is fully seated.
42. Install "H" gage on transaxle pump surface, as
shown in Figure 183, lower the adjustment rod
to the piston surface (See Inset in Figure 183)
of the B1 apply ring/return spring assembly and
tighten the adjustment rod locking knob.
43. Now turn the "H" gage over and set it on the
completed oil pump assembly, "with" the new
design gasket, as shown in Figure 184.
44. Measure with feeler gauge between adjustment
rod and B1 clutch piston to determine the B1
clutch clearance.
45. B1 clutch clearance should be approximately
0.26 mm (.010") per friction plate installed.
Figure 183
Figure 184
Copyright © 2010 ATSG
Continued on Page 110
B1 Clutch Clearance Should Be
Approximately 0.26 mm (.010")
Per Friction Plate Installed
ADJUSTMENT
ROD
RETURN
SPRING
ASSEMBLY
WWW.ALL-TRANS.BY