Service Manual

56 OIL PUMP TO CASE GASKET (LATE DESIGN).
112
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
Continued on Page 113
55. Install new design pump to case gasket over the
dowels on oil pump, as shown in Figure 191, and
retain with a small amount of Trans-Jel®.
56. Install two new case to converter cover seals in
the case pockets, as shown in Figure 190, and
retain with small amount of Trans-Jel®.
57. Install the oil pump and gasket assembly, as
shown in Figure 190.
Note: Rotate the input shaft to engage oil pump
into front sun gear splines.
58. Install the 6 oil pump retaining bolts, as shown
in Figure 190.
Note: Pay close attention to the length of bolts
as positioning is critical.
59. Torque all 6 oil pump bolts to 19 N·m (14 ft.lb.),
as shown in Figure 192.
TRANSAXLE FINAL ASSEMBLY (CONT'D)
Figure 191
7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
3
2
6 1 C
A
56
54
53
53
53
55
54
62
61
61
73
53 OIL PUMP RETAINING BOLT (22 MM LENGTH, 3 REQUIRED).
54 OIL PUMP RETAINING BOLT (30 MM LENGTH, 2 REQUIRED).
55 OIL PUMP RETAINING BOLT (25 MM LENGTH, 1 REQUIRED).
56 OIL PUMP TO CASE GASKETS (LATE DESIGN).
61 CONVERTER COVER TO CASE SEALS (2 REQUIRED).
62 OIL PUMP ASSEMBLY.
73 OIL PUMP TO K3 CLUTCH HOUSING THRUST WASHER (NO. 1).
Figure 190
Copyright © 2010 ATSG
Copyright © 2010 ATSG
56
7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
23
1 6 C
A
Copyright © 2010 ATSG
TORQUE PUMP BOLTS TO
19 N·M (14 FT.LB.)
Figure 192
WWW.ALL-TRANS.BY