Service Manual

117
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
0917
1
T
7C 3 00708A C
0 47 A3 0 70C C
B 3 01371
5 Y A
1 65BX3A0 70
5 0CB3B004 0
A4
U3C00100
Figure 201
26
29
30
31
32
27
28
26 OUTPUT SPEED SENSOR BRACKET BOLT (11 MM LENGTH).
27 TFT SENSOR RETAINING BRACKET.
28 TFT SENSOR RETAINING BRACKET BOLT (11 MM LENGTH).
29 INPUT SPEED SENSOR BRACKET BOLT (11 MM LENGTH).
30 OUTPUT SPEED SENSOR HARNESS OVER PAN RAIL.
31 INPUT SPEED SENSOR HARNESS OVER PAN RAIL.
32 SENSOR AND SWITCH HARNESS OVER PAN RAIL.
Copyright © 2010 ATSG
76. Install the temp sensor into the valve body bore,
install retaining bracket and torque the retaining
bolt to 11 N·m (97 in.lb.) (See Figure 199).
77. Install the output speed sensor "blue" connector
to valve body, as shown in Figure 201, torque
the retaining bolt to 7 N·m (62 in.lb.).
78. Install the input speed sensor "white" connector
to valve body, as shown in Figure 201, torque
the retaining bolt to 7 N·m (62 in.lb.).
79. Connect all 8 solenoid connectors to the proper
solenoids, as shown in Figure 202, using the list
of the wire colors to each of the solenoids that
you prepared during the disassembly process.
Note: Ensure that the harness' are in retaining
brackets and no wires are pinched.
80. Connect wire connectors to both speed sensors,
as shown in Figure 202.
81. Connect both hydraulic switches (if used), as
shown in Figure 202.
82. Install the internal manual shift lever to manual
shaft as shown in Figure 202, and ensure lever
engages into manual valve properly.
83. Install the internal manual shift lever retaining
nut, as shown in Figure 202.
Note: There are two different designs of the
manual lever nut, as shown in Figure 202.
TRANSAXLE FINAL ASSEMBLY (CONT'D)
09
17
1
T
7C 0 03C0 7 8A
A 00
7 47C 3C 0
0 3 1
5B 3A 1 7Y
65 X3 017B A 0
5CB3B0 0004
4A 3 00100U C
Copyright © 2010 ATSG
21
22
25
23
24
Figure 202
21 MANUAL SHAFT LEVER RETAINING NUT (SOME MODELS).
22 RETAINING NUT LOCKING TAB WASHER (SOME MODELS).
23 MANUAL SHAFT LEVER NUT WITH SHOULDER (SOME MODELS).
24 MANUAL SHAFT LEVER CENTERING WASHER (SOME MODELS).
25 INTERNAL MANUAL SHAFT LEVER.
Continued on Page 118
WWW.ALL-TRANS.BY