Service Manual

111
112
113
114
116
117
118
119
120 135
115
REAR VIEW
REAR VIEW
111 NUMBER 2 THRUST WASHER.
112 FRONT PLANETARY SUN GEAR.
113 FRONT PLANETARY CARRIER ASSEMBLY.
114 NUMBER 4 THRUST WASHER.
115 INPUT SHAFT SEALING RINGS (3 REQUIRED).
116 NUMBER 3 THRUST BEARING.
117 NUMBER 3 THRUST BEARING RACE.
118 FRONT PLANETARY RING GEAR AND INPUT SHAFT ASSEMBLY.
119 NUMBER 5 THRUST BEARING.
120 NUMBER 5 THRUST BEARING RACE.
135 K1 CLUTCH SEALING RINGS (2 REQUIRED).
FRONT PLANETARY AND ASSOCIATED PARTS, EXPLODED VIEW
Figure 138
FRONT PLANETARY ASSEMBLY
COMPONENT REBUILD (CONT'D)
1. Disassemble the front planetary assembly using
Figure 129 as a guide.
3. Clean all front planetary parts thoroughly and
dry with compressed air.
3. Inspect all front planetary parts thoroughly for
any wear and/or damage, replace as necessary.
WARNING: At time of this printing, there are not
any new "hard parts" available from the
manufacturer for this unit. The only source will be
used aftermarket suppliers.
Continued on Page 85
84
Copyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
WWW.ALL-TRANS.BY