Operation Manual

DO-IT-YOURSELF SERVICE
§ Turn bulb holder counter-clockwise
and pull out.
139
§ Press defective bulb into holder, turn
counter-clockwise, remove and install
new bulb.
§ Push bulb holder into
and turn clockwise until firmly
light housing
d.
by
er
t unit
seate
Reinstall side marker light un§ it
fitting light housing into upper and low
guide rails (arrow). Push in ligh
evenly as far as it will go.
Front turn signal light bulbs
and
tly press bulb into holder, turn
onet socket so that the
§ Remove both Philips screws
pull out lamp housing.
§ Turn bulb socket clockwise and pull
out.
§ Gen
and remove.
§ Install new bulb.
§ Reinstall bay
bayonet fittings engage properly in the
lamp housing. Then turn bulb socket
counter-clockwise.
§ Reinstall lamp housing.
Tail lights in fender
§ Open trunk lid.
§ Loosen both knurled screws and
remove cover.
§ Push in tabs (arrows) and remove
light base plate.
§ Replace bulb.
To change the bulb, pr
bulb lightly into the bulb holder,
ess the defective
turn to
the left and take out. Insert new bulb by
pressing lightly into holder and turning to
the right.
§ Reinstall light base plate. Tabs must
snap into place.
1 – Turn signal
2 – Tail light
3 – Tail light / Brake light