Operation Manual

DO-IT-YOURSELF SER
140
§ Open rear lid.
§ Remove left or right side trim.
§ Remove compact spare wheel on
the left, first aid kit and warning triangle
on the right.
§ Reach into the space between the
trim and side panel, push in tabs (see
arrows in figure B 43-236 on previous
page) and remove base plate.
l light base plate. Tabs must
Tail lights in side panel
(Wagon/Avant)
VICE
§ Replace bulb.
§ Reinstal
snap into place.
Center stop light in rear window
§ Press tabs (a) and pull off backface
(b) in direction of arrow
§ Replace defective bulb
§ Push backface on to tab in opposite
direction of arrow (b)
Both tabs must securely snap into tab
openings.
Center stop light in
(Wagon/Avant)
rear window
e opening and tilt in
(A) {see illustration). At
p unit on the guide rails
window until it
§ Open rear lid.
§ Push through both plugs into inside
of lamp housing.
§ To release lamp unit insert a
screwdriver into th
direction of arrow
the same time press lamp up gently.
Repeat procedure on other side of lamp.
§ Push the lamp unit up until it stops
and remove.
§ Press tabs (B} and remove back-
face, replace defective bulb. Remount
backface.
m§ Place la
and push along the rear
stops.