Operation Manual

CONTROLS AND EQUIPMENT
68
Defogging or defrosting of windshield
and side windows:
§ Turn fan control A to
§ Turn temperature control B all the
way to the right.
§ Turn air distribution control C to
§ Close center vents 4.
§ Open side vents 3 and direct air flow
towards the side windows.
Keeping windshield and side windows
clear
This setting is recommended if the
windows should mist over in wet or
humid conditions:
§ Turn fan control A to II or III.
§ Turn temperature control B clock-
wise as necessary.
§ Close vents 4.
§ Depress switch E if the windows
mist over when driving with the air
conditioner switched on in very hot and
humid outside air conditions.
Warming up interior quickly
§ Turn fan control A to IIII.
§ Turn temperature control B all the
way to the right.
§ Turn air distribution control C to
§ Open vents 3 and 4.
Warming up interior comfortably
Once the windshield and side windows
are clear and the interior is warmed up,
you may want to set the controls as
follows:
§ Turn fan control A to ll or III.
§ Turn temperature control B to
desired position.
§ Turn air distribution control C to
§ Set vents 3 and 4 as desired.
Outside airventilation
You get maximum outside airflow from
vents 3 and 4 when the air distribution
control is set to .
The air temperature coming from vents3
and 4 can be adjusted from cold to warm
by setting the temperature control
accordingly.
Maximum cooling
§ Close all windows and sun roof
*
.
§ Depress switches D and E. The
indicator lights in both switches will come
on.
§ Turn temperature control B all the
way to the left.
§ Turn fan control A to IIII.
§ Turn air distribution control to .
§ Open vents 3 and 4 and set as
required.
To prevent the cooling system from icing
up, at least one vent must always be
open.
*
where applicable