Service & Repair Manual

24-23
Installing
Installation is reverse of removal, noting the following:
Important note:
After installing new Engine Control Module (ECM), the following work
steps must be performed:
- Check DTC memory and erase it if necessary Page 01-15 .
- Perform adaptation of the Throttle Valve Control Module -J338- Page
24-142 .
- Using a screwdriver, carefully pry off retaining bracket (arrow).
- Disengage locking lugs and remove control module connector.
- Remove Engine Control Module (ECM).
Pa
g
e 25 of 78Motronic in
j
ection s
y
stem, servicin
g
11/23/2002htt
p
://127.0.0.1:8080/audi/servlet/Dis
p
la
y
?action=Goto&t
yp
e=re
p
air&id=AUDI.B5.FU05.24.1