Service & Repair Manual

24-72
Component location Overview of component
locations, page Page 24-5
Test requirement:
Output Diagnostic Test Mode (DTM)
performed
Fuse for intake manifold change-over valve
is OK
Electrical Wiring Diagrams, Troubleshooting &
Component Locations binder
Fuel Pump (FP) OK, checking Page 24-
49 .
Checking internal resistance
- Disconnect connector from Intake Manifold
Change-Over Valve -N156-.
- Connect multimeter at valve for resistance measurement.
Specification: 25 to 35
- Replace Intake Manifold Change-Over Valve -N156- if specified value
is not obtained.
Pa
g
e 7 of 10Intake manifold chan
g
e-ove
r
11/23/2002htt
p
://127.0.0.1:8080/audi/servlet/Dis
p
la
y
?action=Goto&t
yp
e=re
p
air&id=AUDI.B5.FU05.24.2