Service & Repair Manual

24-199
If you cannot determine a cause for the DTC
"Powertrain databus malfunction, check
whether the DTC is caused by one of the
control modules.
All control modules that use the CAN-bus are still
disconnected. Ignition is switched off.
- Connect one of the control modules.
- Connect VAG 1551 scan tool. Switch ignition on,
and erase the DTC memory of the control
module you just connected. End scan tool output
using the "End Output" function 06.
- Switch ignition off and then on.
- Leave ignition on for 10 seconds. Then, read the
DTC memory of the control module you just
connected.
- If the DTC "Powertrain databus malfunction" is
displayed, replace the control module you just
connected.
- If the DTC "Powertrain databus malfunction" is
not displayed, connect the next control module
and repeat the procedure.
Pa
g
e 44 of 44Additional si
g
nals, testin
g
11/23/2002htt
p
://127.0.0.1:8080/audi/servlet/Dis
p
la
y
?action=Goto&t
yp
e=re
p
air&id=AUDI.B5.FU05.24.6