Service & Repair Manual

28-47
Note:
Voltage testers do not go out completely during
low current pick-up between activations by the
ECM, but rather continue to glow a little and then
get significantly brighter during activation.
If LED does not blink:
Checking voltage supply
- Disconnect connector at respective Camshaft
Position (CMP) sensor.
- Switch ignition on.
- Connect multimeter for voltage measurement as follows:
Harness connector
Terminal
Measure to
1 Engine Ground (GND)
Specification: about 5 V
Pa
g
e 52 of 65I
g
nition s
y
stem, checkin
g
11/23/2002htt
p
://127.0.0.1:8080/audi/servlet/Dis
p
la
y
?action=Goto&t
yp
e=re
p
air&id=AUDI.B5.FU05.28.1