Service & Repair Manual

28-48
Checking signal wire
Checking Ground (GND) wire
If all specified values are being reached and the LED does not blink
(measured between terminal 1 and 2 with starter and connector
connected):
- Connect multimeter for voltage measurement as follows:
Harness connector
Terminal
Measure to
2 Engine Ground (GND)
Specification: approx. battery voltage
- Connect multimeter for voltage measurement as follows:
Harness connector
Terminal
Measure to
3 B+
Specification: approx. battery voltage
- Repair open circuit or short circuit if necessary.
- Replace respective Camshaft Position (CMP) sensor.
Pa
g
e 53 of 65I
g
nition s
y
stem, checkin
g
11/23/2002htt
p
://127.0.0.1:8080/audi/servlet/Dis
p
la
y
?action=Goto&t
yp
e=re
p
air&id=AUDI.B5.FU05.28.1