Service & Repair Manual

28-50
- Repair open circuit or short circuit if
necessary.
- If, after erasing DTC memory for the sake of the
test, a DTC relating to the Camshaft Position
(CMP) sensor (hall sensor) is indicated again,
even though all previous tests were OK, the
following malfunction is possible:
Shutter wheel for Camshaft Position (CMP)
sensor is not aligned properly.
Check phase position of Camshaft Position
(CMP) sensor
- Connect VAS5051 tester or VAG1551 scan tool
and select the control module for engine
electronics using "address word" 01 Page 01-
9 .
Engine must run at idle for this.
Rapid data transfer HELP
Select function XX
When indicated on display:
- Press buttons -0- and -8- to select "Read Measuring Value Block" and
press -Q- button to confirm input.
Read Measurin
g
Value Block Q
Input display group number XXX
When indicated on display:
Pa
g
e 56 of 65I
g
nition s
y
stem, checkin
g
11/23/2002htt
p
://127.0.0.1:8080/audi/servlet/Dis
p
la
y
?action=Goto&t
yp
e=re
p
air&id=AUDI.B5.FU05.28.1