Unit installation

60
Diagnosis
The central control unit for convenience
system, J393, has the usual diagnostic functions,
such as read fault memory, read measured value
blocks, adaptation, coding, as well as selective and
sequential actuator test at its disposal.
Actuator test
The selective actuator test initiated by the diagnosis
tester can be used to check the following actuators:
Indicator light for safe central locking K133
(in door rim)
Lock central locking signal (once)
Activate safe locking for doors (once)
Unlock central locking signal
Lock filler flap
Unlock filler flap
Lamp for left brake light M9
Lamp for right brake light M10
Lamp for high-level brake light M25
Lamps for tail light, left
Lamp for parking light, left M43
Lamps for tail light, right
Lamp for parking light, right M44
Lamp for reversing light, left M16
Lamp for reversing light, right M17
Lamp for direction indicator light, rear left M6
Lamp for direction indicator light, rear right M8
Lamp for rear fog light, left L46
Lamp for rear fog light, right L47
Coding
This diagnostic option can be used to perform
coding, for example, for these functions:
Anti-theft warning system
Central locking (normal/selective)
–Tilt sensor
Passenger compartment sensor
Convenience function via radio
–Right-hand traffic
–Avant detection
–Rear sun blind
Convenience electrics
Note
In addition to the selective actuator test,
the diagnosis software also includes the option
of a sequential actuator test.
Number plate light X
Boot light W3
Footwell light, rear left W45
Footwell light, rear right W46
Activation of rear lid remote unlocking
(rotary latch opens, closing aid moves up)
Motor for rear sun blind (rear sun blind moves in
both directions)
Signal for rear window heater activation
–Interior lighting
Acknowledgement of anti-theft warning system
horn
–RoW/USA
–Light package
Tank cap lock detection
Equipment (Basic/High-Line)
–Sliding roof
Multi-function control unit (taxi/emergency
doctor/fire brigade, installed/not installed)