Specifications

Address: 1000 Seville Road, Wadsworth, OH 44281
Phone: [phone]
Web: www.ecstuning.com
Page -
13
B5 S4 Timing Belt Kit Installation
Step 11.
With cam and crank marks aligned, install the
crankshaft locking tool.
Remove the plastic plug located in the side of the
engine. It is held in place by a single 6mm bolt, and
seals to the block with an o-ring.
With the plug removed, screw the threaded locking
tool into the block until it engages the crankshaft,
locking it in place.
Step 10.
With the crank at TDC, make sure the larger holes in
the cam alignment plates face toward the center of the
engine. If not, rotate the crankshaft another complete
turn until the TDC marks align again. en t the
camshaft tool pins into the cam alignment plates.
Step 12.
Here’s a shot from under the car that shows the locking
tool installed in the block. e access hole for the tool is
on the left side of the block, slightly above the oil pan,
near the bell housing.
Tighten the lock with a 10mm wrench; don’t
overtighten, just snug it.