Specifications
9
PHONO CARTRIDGE LOADING ADJUSTMENT
The phono cartridge load can be adjusted to suit your particular phono cartridge, using two pairs of
internal blue mini-switches.
The Jarrah mini-switches are factory set to a 47kΩ load. Also, switch 1 is set in the on position. This is a
220pF capacitive setting and is usually required for RF suppression. It is not recommended that you turn
switch 1 off.
Disconnect the lead from the IEC socket on your Plinius Jarrah. Carefully remove the lid by undoing the
six cap screws. Locate the blue mini-switch banks to the rear of the circuit board. Adjust the settings of
the five individual switches (remember to do both channels) to give a loading required with reference to
the table below.
LOAD
REQUIRED
SWITCH NUMBER AND SETTING
1 2 3 4 5 6
LOAD
REQUIRED
SWITCH NUMBER AND SETTING
1 2 3 4 5 6
7.4Ω
ON ON ON ON ON ON
29Ω
ON ON ON ON ON
7.5Ω
ON ON ON ON ON
30Ω
ON ON ON ON
7.6Ω
ON ON ON ON ON
31Ω
ON ON ON ON
7.7Ω
ON ON ON ON
32Ω
ON ON ON
8.0Ω
ON ON ON ON ON
41Ω
ON ON ON ON
8.1Ω
ON ON ON ON
43Ω
ON ON ON
8.2Ω
ON ON ON ON
45Ω
ON ON ON
8.3Ω
ON ON ON
47Ω
ON ON
8.8Ω
ON ON ON ON ON
76Ω
ON ON ON ON
8.9Ω
ON ON ON ON
82Ω
ON ON ON
9.0Ω
ON ON ON ON
90Ω
ON ON ON
9.1Ω
ON ON ON
100Ω
ON ON
9.7Ω
ON ON ON ON
320Ω
ON ON ON
9.8Ω
ON ON ON
470Ω
ON ON
9.9Ω
ON ON ON
1kΩ
ON ON
10.0Ω
ON ON
47kΩ
ON
Now reassemble your Plinius Jarrah.