Operation Manual

Unit command format
Command
Type
RS-232
Command
MULTIzone command response
UNIT $sXXsbyoff Unit Y enters standby
UNIT $sXXsbyon Unit Y powers up from standby
UNIT $sXXmuten Unit Y all zones enter mute
UNIT $sXXmutdis Unit Y all zones de-mute
UNIT $sXXcomen Unit Y all zones enter RS-232 control mode
UNIT $sXXcomdis Unit Y all zones enter manual front panel control mode
Where
XX =
Responding unit Y
DIP switch address
01 1
05 2
09 3
13 4
17 5
21 6
25 7
Zone command format
As a number of MULTIzone units can be looped together the zone command should refer to the absolute zone within the loop.
i.e. in a system with three MULTIzone units, zone 2 of unit 3 would be referenced as zone 10.
Command
Type
RS-232 Command Note
DIP switch setting
Switch 3 Switch 2 Switch 1
UNIT $s01<CMD> Command only applies to unit1 zone 1 0 0 1
UNIT $s02<CMD> Command only applies to unit1 zone 2 0 0 1
UNIT $s03<CMD> Command only applies to unit1 zone 3 0 0 1
UNIT $s04<CMD> Command only applies to unit1 zone 4 0 0 1
UNIT $s05<CMD> Command only applies to unit 2 zone 1 0 1 0
UNIT $s06<CMD> Command only applies to unit 2 zone 2 0 1 0
UNIT $s07<CMD> Command only applies to unit 2 zone 3 0 1 0
UNIT $s08<CMD> Command only applies to unit 2 zone 4 0 1 0
UNIT $s09<CMD> Command only applies to unit 3 zone 1 0 1 1
UNIT $s10<CMD> Command only applies to unit 3 zone 2 0 1 1
UNIT $s11<CMD> Command only applies to unit 3 zone 3 0 1 1
UNIT $s12<CMD> Command only applies to unit 3 zone 4 0 1 1
UNIT $s13<CMD> Command only applies to unit 4 zone 1 1 0 0
UNIT $s14<CMD> Command only applies to unit 4 zone 2 1 0 0
UNIT $s15<CMD> Command only applies to unit 4 zone 3 1 0 0
UNIT $s16<CMD> Command only applies to unit 4 zone 4 1 0 0
UNIT $s17<CMD> Command only applies to unit 5 zone 1 1 0 1
UNIT $s18<CMD> Command only applies to unit 5 zone 2 1 0 1
UNIT $s19<CMD> Command only applies to unit 5 zone 3 1 0 1
UNIT $s20<CMD> Command only applies to unit 5 zone 4 1 0 1
UNIT $s21<CMD> Command only applies to unit 6 zone 1 1 1 0
UNIT $s22<CMD> Command only applies to unit 6 zone 2 1 1 0
UNIT $s23<CMD> Command only applies to unit 6 zone 3 1 1 0
UNIT $s24<CMD> Command only applies to unit 6 zone 4 1 1 0
UNIT $s25<CMD> Command only applies to unit 7 zone 1 1 1 1
UNIT $s26<CMD> Command only applies to unit 7 zone 2 1 1 1
UNIT $s27<CMD> Command only applies to unit 7 zone 3 1 1 1
UNIT $s28<CMD> Command only applies to unit 7 zone 4 1 1 1
10