User Guide

17
SETUP
2. PLL
SETUP: PLL
2.2.1: SRC OFF
SETUP: PLL
2.2.2: SRC X1
SETUP: PLL
2.2.3: SRC X2
SETUP: PLL
2.2.4: SRC X4
SETUP: PLL
2.1: Exit
SETUP: PLL
2.2: ON
PLL Mode Sub Menu
Sotto menu Modalità PLL
Exit from the setup menu.
Uscire dal menu setup.
Confirm the activation of the PLL Mode. Pressing OK(5) enters a specific submenu where you
can enable or disable the SRC and select the Up-Sampling factor.
Conferma l’attivazione della modalità PLL. In questo caso premendo OK(5) si entra in un sotto
menù specifico dove è possibile attivare o meno il SRC e selezionare il fattore di UP-Sampling.
De-active the SRC (so the DAC will work at the frequency of 44,1KHz) and it exits the
setup, the unit goes back to the normal operation state.
Permette di disattivare il SRC, (In questo modo il DAC lavora alla frequenza di
44,1KHz), ed esce dal setup, l’apparecchio torna allo stato di normale funzionamento.
Select the Up-Sampling rate to X1 (the system clock to the SRC is supplied by the PLL)
and it exits the set up, the unit goes back to the normal operation state.
Seleziona il tasso di Up-Sampling a X1 (il system clock al SRC è fornito dal PLL) ed
esce dal setup, l’apparecchio torna allo stato di normale funzionamento
Select the Up-Sampling rate to X2 (the system clock to the SRC is supplied by the PLL.
The DAC works at the sample frequency of 44,1KHz by two that’s say 88,2KHz) and it
exits the set up, the unit goes back to the normal operation state.
Seleziona il tasso di Up-Sampling a X2 (il system clock al SRC è fornito dal PLL. Il DAC
lavorerà alla frequenza di 44,1KHz per 2, ovvero a 88,2KHz) ed esce dal setup,
l’apparecchio torna allo stato di normale funzionamento.
Select the Up-Sampling rate to X4 (the system clock to the SRC is supplied by the PLL.
The DAC will work at the frequency of 44,1KHz by four, that’s say: 176,4KHz) and it
exits the set up, the unit goes back to the normal operation state.
Seleziona il tasso di Up-Sampling a X4 (il system clock al SRC è fornito dal PLL. Il DAC
lavorerà alla frequenza di 44,1KHz per 4, ovvero a 176,4KHz) ed esce dal setup,
l’apparecchio torna allo stato di normale funzionamento.
Note: In PLL Mode it is not possible to select the S/PDIF digital input as input for the audio chain but this modality works only with the
CD mechanism SPDIF digital audio output signal.
Nota: In modalità PLL non è possibile selezione l’ingresso digitale S/PDIF come ingresso per la catena audio digitale, infatti la
modalità PLL è applicabile solo al segnale digitale SPDIF proveniente dalla meccanica CD.