User Manual Model 1185ci HDTV Signal Distribution Amplifier
Model 1185ci HDTV Signal Distribution Amplifier Table Of Contents 1.0 Introduction . . . . . . . . . . . . . . . . . . . . . . . 2 1.1 Liability Statement 3.0 Checking Package Contents . . . . . . . . . . . . . . . 3 4.0 Installation . . . . . . . . . . . . . . . . . . . . . . . . 5 5.0 Troubleshooting . . . . . . . . . . . . . . . . . . . . . 5 6.0 Limited Warranty . . . . . . . . . . . . . . . . . . . . 6 7.0 Specifications 8.0 Regulatory Compliance . . . . . . . . . . . . . . . . . 7 9.
1.1 Liability Statement Every effort has been made to ensure that this product is free of errors. Audio Authority cannot be held liable for the use of this hardware or any direct or indirect consequential damages arising from its use. It is the responsibility of the user of the product to check that it is suitable for his/her requirements and that it is installed correctly. All rights reserved.
POWER CONNECTION 12V DC POWER 1 2 Y OPTICAL COAX DIGITAL AUDIO VIDEO POWER INDICATOR OPTICAL COAX DIGITAL AUDIO DIGITAL AUDIO VIDEO Pb L Y Pr R Pb L Pr R 3 OPTICAL COAX DIGITAL AUDIO VIDEO Y Made in USA • Audio Authority, Lexington, Kentucky 800-322-8346 • 859-233-4599 • www.audioauthority.com ANALOG AUDIO -ORH AND V SYNC WHEN IN RGB MODE * IN RGB mode, be sure to connect H and V to the analog left and right audio jacks.
4.0 INSTALLATION Connect the input port to a source of Component or RGB video using high-quality patch cables. Connect each of the four outputs to its destination television using coaxial cable suitable for baseband video, such as RG-59 with a solid copper center conductor. Do not use RG-6 or steel-core cable. Plug the included 12 volt DC power supply into the Model 1185ci Power jack and plug the wall adapter into an AC outlet. 4.
we will replace the defective product at no cost. Freight charges for the replacement unit will be paid by Audio Authority (ground service only). A copy of the invoice showing the item number and date of purchase (proof-of-purchase) must be submitted with the defective unit to constitute a valid in-warranty claim. Units that fail after the warranty period has expired may be returned to the factory for repair at a nominal charge, if not damaged beyond the point of repair.
.0 SPECIFICATIONS Video Parameters Signal Type Component/RGBHV Video Resolutions Supported All, including 480i/p, 720p, 1080i/p Input/Output Impedance 75 ohms Input Ground Isolation No Gain Unity gain (1-to-1) Gain Accuracy 1% 3dB Bandwidth 250MHz Input Coupling AC/sync tip clamped S/N Ratio 65dB Max Gain/Equalization 1 Audio Parameters Analog/Digital Digital/Analog Digital Input/Output Type Optical+Coaxial In/Out Input Impedance 75 ohms/10K ohms Min Load Impedance 75 ohms/10K oh
9.0 CONTACT INFORMATION If you have questions or require assistance with this product in areas not covered by this manual, please contact Audio Authority using the information below. Audio Authority Technical Service 800-322-8346 M-F 8:30 AM to 5:00 PM, EST International: 859-233-4599 Fax: 859-233-4510 Send email to: support@audioauthority.
