User manual

6
7
4.2 Connecting the Output
The 1362 scaler can output analog RGBHV or YPbPr formats up to
UXGA and 1080p. RGBHA and YPbPr are both available on the HD-
15 output connector. When a PC (RGBHV) output is used, select an
HD-15 to HD-15 cable to connect the 1362 output to the destination
device. When an HDTV (YPbPr) output is used, select an HD-15 to 3-
RCA cable to connect the 1362 output to the destination device.
YCbCr
IN
SV
IN
CV
IN
DC 5V
PC/HD OUT
480p XGA
MENU
4.3 Connecting Power to the Unit
The 1362 is shipped with an in-plug power adapter to convert
100~240VAC@50-60Hz to 5VDC. Connect the DC output cord from
the power adapter to the back of the unit and then plug the power
adapter into an AC receptacle; the power LED indicator illuminates.
5.0 OPERATING THE UNIT
The 1362 does not automatically sense the input you have
connected. You must identify the active input by pressing the + key
before you activate the menu. Power all components in the signal
path and press the + key until the correct input name appears in the
upper right corner of the screen: composite, S-video, YCbCr, RGsB.
5.1 Settings
The 1362 is controlled via three buttons with status indicated by OSD
(On Screen Display). See the menu map on page 9.
• Menu Button: This button displays the menu options via the OSD
on the display device connected to the output.
• + and – Buttons: These buttons allow navigation within the menu
and adjustments of the parameters available.
• XGA Reset: Simultaneously pressing the – and + buttons returns
settings to factory defaults and sets the output to XGA for PC
monitors.
• 480p Reset: Simultaneously depressing the menu and – buttons
returns settings to factory defaults and sets the output to 480p for
HDTV displays.