User manual

Siqura A-80
Page 42
CC Output # Settings, Receiver
Advanced Settings, CC Output #,
Receiver
Receiver
Source port filter
Can be used to filter incoming data traffic. With multiple signals sent to the same
IP address and destination port number, Source port filter can be used to filter the
input, that is - to accept only data from the transmitting port specified here. The
filter will not be active if set to 0 (the default and recommended setting).
Connection priority
Parameter intended for use with MX Software Development Kit (MX SDK).
Reorder buffer size
Used to reorder incoming packets.
Stream fail delay
Range: [0...10000] ms. Default: 300 ms. Timeout in ms before going to NoStream
state.
Link loss alarm timeout
Range: [1...1000] s. Default: 10 s. Time in seconds before alarm sent.