User Manual Model EDP-11 Cat 5 HDMI Extender System 1384TD and 1384RD Transmitter / Receiver Wallplates Model 1384RD Receiver Model 1384TD Transmitter www.audioauthority.com 800-322-8346 www.audioauthority.com 800-322-8346 Model 1384RD Receiver Model 1384TD Transmitter www.audioauthority.com 800-322-8346 www.audioauthority.
User Manual Model EDP-11 Cat 5 HDMI Extender System WARNINGS • • • • • • • Read these instructions before installing or using this product. To reduce the risk of fire or electric shock, do not expose this unit to moisture. This product must be installed by qualified personnel. Do not open the case—there are no user-serviceable parts inside. Do not expose this unit to excessive heat. Install only in dry, indoor locations. Clean the unit only with a dry or slightly dampened soft cloth.
Table Of Contents 1.0 Introduction . . . . . . . . . . . . . . . . . . . . . . . 4 2.0 Checking Package Contents . . . . . . . . . . . . . . . 4 3.0 Installation . . . . . . . . . . . . . . . . . . . . . . . . 5 4.0 Troubleshooting . . . . . . . . . . . . . . . . . . . . . 7 5.0 Specifications 6.0 Limited Warranty . . . . . . . . . . . . . . . . . . . . 9 7.0 Regulatory Compliance . . . . . . . . . . . . . . . . 10 8.0 Contact Information . . . . . . . . . . . . . . . . . . 10 . . . . . .
1.0 INTRODUCTION Thank you for purchasing this Cat 5 HDMI extender system from Audio Authority. The EDP-11 transmits HDMI signals digitally over Cat 5 cables. Using Cat 5e or Cat 6 cables allows installers to use less expensive wire over longer distances, and terminate the cables in the field. The EDP-11 can achieve distances from 115 to 195 feet depending on the type of cable used, and the resolution and audio bit rate of the source and sink.
er m 3.0 INSTALLATION Before connecting the EDP-11 Cat 5 extender system, verify that the display device on the receiving end can support the output resolution and signal format by connecting it directly to the source device via a short, known good, HDMI cable. The panel drawings below show the Cat 5 signal output/input connections, power connection. Receiver Transmitter Model 1384RD FRONT VIEW Model 1384TD FRONT VIEW HDMI INPUT FROM SOURCE HDMI OUTPUT TO SINK (E.G.
3.1 TERMINATING CAT 5E/6 UTP CABLES Cut two Cat 5e/6 cables exactly the same length (within four inches). Terminate the cables using the standard EIA 568B pairing shown below. WHITE / ORANGE ORANGE WHITE / GREEN BLUE WHITE / BLUE GREEN WHITE / BROWN BROWN 1 2 3 4 5 6 7 8 1384RD END (IDENTICAL) WHITE / ORANGE ORANGE WHITE / GREEN BLUE WHITE / BLUE GREEN WHITE / BROWN BROWN 1384TD END 1 2 3 4 5 6 7 8 Correct pairing is vital, and should always be checked with a network cable tester.
Again, always test the HDMI source on the intended display with a known good HDMI cable before using the EDP-11. This precaution insures that the source can be (and is) set to a resolution that is compatible with the display, and that both are functioning correctly together. 3. At the remote location, connect the appropriate Cat 5 cables to the Cat 5 Input 1 and 2 connectors of the 1384RD Receiver. Be careful not to interchange the 1 and 2 cables. 4.
5.0 SPECIFICATIONS Digital Audio/Video I/O 1384TD Transmitter – HDMI In 1x via HDMI connector 1384RD Receiver – HDMI Out 1x via HDMI connector Cat 5e/6 Connections I/O 1384TD Transmitter – Cat 5e/6 output 2x via RJ-45 (1 & 2) 1384RD Receiver – Cat 5e/6 input 2x via RJ-45 (1 & 2) Performance Maximum resolution Up to 1920x1200, 1080p/60Hz TMDS clock speed 225MHz Data bit rate 2.
6.0 LIMITED WARRANTY If any consumer product from Audio Authority fails due to defects in materials or workmanship within one year from the date of the original sale to the enduser, Audio Authority guarantees that we will replace the defective product at no cost. Freight charges for the replacement unit will be paid by Audio Authority (ground service only).
7.0 REGULATORY COMPLIANCE The EDP-11 system has been tested for compliance with CE and FCC rules and regulations. The Power Adaptor/Supply included has been tested for compliance with UL, CUL, CE, PSE, and GS rules and guidelines. This product and its power supply are RoHS compliant. 8.0 CONTACT INFORMATION If you have questions or require assistance with this product in areas not covered by this manual, please contact Audio Authority using the information below.
2048 Mercer Road, Lexington, Kentucky 40511-1071 Phone: 859-233-4599 • Fax: 859-233-4510 Customer Toll-Free USA & Canada: 800-322-8346 www.audioauthority.
