Corp. Cat 5 HDMI Extender System User Manual

3.1 TERMINATING CAT 5E/6 UTP CABLES

Cut two Cat 5e/6 cables exactly the same length (within four inches). Terminate

the cables using the standard EIA 568B pairing shown below.

Correct pairing is vital, and

should always be checked with a

network cable tester. The correct

pairing is straight through, pin-to-

pin, as shown.

1384TD END 1384RD END

(IDENTICAL)

5 WHITE / BLUE

7 WHITE / BROWN

6 GREEN

3 WHITE / GREEN

2 ORANGE

4 BLUE

8 BROWN

1 WHITE / ORANGE

5 WHITE / BLUE

7 WHITE / BROWN

6 GREEN

3 WHITE / GREEN

2 ORANGE

4 BLUE

8 BROWN

1 WHITE / ORANGE

3.3 CONNECTING THE HARDWARE

1. Connect the HDMI source device’s output to the HDMI INPUT connector of the

1384TD Transmitter, using a short, high quality, HDMI cable.

2. Connect a correctly terminated and tested Cat 5 cable to the Cat 5 Output

1 connector of the Transmitter. Connect a second Cat 5 cable to the Cat 5

Output 2. Mark the cables at both ends so that you do not inadvertently swap

them. Do not connect the AC adapter until the Cat 5 cables are correctly

connected to both the transmitter and the receiver.

Cat 5e