Corp. Cat 5 HDMI Extender System User Manual

6
7
Again, always test the HDMI source on the intended display with a known
good HDMI cable before using the EDP-11. This precaution insures that the
source can be (and is) set to a resolution that is compatible with the display,
and that both are functioning correctly together.
3. At the remote location, connect the appropriate Cat 5 cables to the Cat 5 Input
1 and 2 connectors of the 1384RD Receiver. Be careful not to interchange the
1 and 2 cables.
4. Connect the HDMI OUTPUT of the 1384RD to the HDMI input of the video
display or other device, using the appropriate cable.
5. Connect the supplied AC adapter rst to the 1384TD and then to the AC outlet.
6. Turn on the source device and video display. The source video signal should
appear on the display. If not, consult the Troubleshooting Guide in this manual.
4.0 TROUBLESHOOTING
• Check all of the HDMI connections to see if any of the connectors have
become loose.
• Make certain the 1384TD is connected to a live AC outlet and check the power
indicators on both units.
• Use a network cable tester to make certain your Cat 5e/6 cable is terminated
correctly and the RJ-45 connectors are securely attached to the cable at both
ends. Check for cable defects or damage.
• Temporarily connect the display device directly to the source with the 1384TD
HDMI connection cable, then test with the 1384RD connection cable. If an
image is present under those circumstances the display, the source, and the
HDMI cables can be eliminated as the cause of the problem. Make sure A/V
receiver is compatible
• If the above circumstances do not produce a picture, try a short, known good
HDMI cable, and make sure the source is set up to output a resolution that the
display can accept.
If you encounter difculty, contact the Audio Authority Technical Support
department via email: [e-mail], or call 800-322-8346 or 859-
233-4599.