User Manual HDMI BYPASS RS-232 IN HDMI IN Audio Authority® Model HBT200T HDBaseT Transmitter Model HBT200T and Model HBT200R HDMI® and Control Signal Extension System POWER IR OUT DC 5V HDMI BYPASS IR IN HDCP LINK CAT5/6 OUT RS-232 IN HDMI IN RS-232 OUT HDMI OUT Audio Authority® Model HBT200T HDBaseT Transmitter Audio Authority® Model HBT200R HDBaseT Zone Receiver Model HBT200T POWER IR OUT DC 5V IR IN HDCP LINK IR OUT DC 5V IR IN CAT5/6 OUT HDCP LINK CAT 5/6 IN Model HBT200R RS-2
Liability Statement Every effort has been made to ensure that this product is free of defects. Audio Authority® cannot be held liable for the use of this hardware or any direct or indirect consequential damages arising from its use. It is the responsibility of the user of the hardware to check that it is suitable for his/her requirements and that it is installed correctly. All rights reserved.
HBT200 Series Model HBT200T and Model HBT200R HDMI® and Control Signal Extension System Table Of Contents 1.0 Introduction . . . . . . . . . . . . . . . . . . . . . . . . 4 2.0 Checking Package Contents . . . . . . . . . . . . . . . . 4 3.0 Applications . . . . . . . . . . . . . . . . . . . . . . . . 5 4.0 Connectors and Indicators. . . . . . . . . . . . . . . . . 6 5.0 Installation . . . . . . . . . . . . .
1.0 INTRODUCTION Thanks for purchasing this HBT200 series signal extender from Audio Authority®, perfect for use in homes, restaurants, classrooms, boardrooms, and retail stores. This system is designed to extend HDMI® and control signals over a single Cat 5e/6 cable up to 330 feet without compression. The HBT200 series supports two-way IR and RS-232 signal transmission in addition to uncompressed HDMI audio/video formats. Supports 3D content, deep color video and Dolby TrueHD and DTS-HD Master Audio.
3.0 APPLICATIONS The diagrams below illustrate connections and functions for HBT200 Series extension applications. These functions can be combined in the same system. Serial Control A control system sends RS-232 commands to the TV to control on/off, input selection, etc. The TV can respond with a confirmation message. HDMI SOURCE CONTROL DEVICE HDMI TV SERIAL SERIAL NOTE: DIAGRAMS DO NOT SHOW POWER CONNECTIONS TX RX CAT 5e/6 CABLE UP TO 330 FT.
4.0 CONNECTIONS AND INDICATORS The transmitter and receiver panels are shown below. Note the following: • HDMI BYPASS this port is provided for troubleshooting purposes. If a display device is connected to the BYPASS port the Cat 5 output is disabled. • RS-232 ports provide a 2-way communication pathway via the Cat 5 cable. • HDCP indicator lights red when content is HDCP encrypted, and flashes when content is not encrypted. • LINK indicator lights yellow when video source and display are connected.
5.0 INSTALLATION Study the front and rear panel drawings and become familiar with the controls, signal input, outputs and power input. 5.1 Wiring the System for Video Transmission • Connect an HDMI approved cable from the HDMI source to the input of the HBT200T, and from the HBT200R to the display device. • Make certain that the HDMI cables are securely plugged into the source and display devices as well as the HBT200 units.
6.0 TROUBLESHOOTING • For 1080p resolution, first make certain that the input cable is as short as possible and none of the HDMI cables are more than three meters long. HDMI cable design and quality are extremely important in long cable runs where capacitance can severely effect performance. • Make certain that the HBT200 units are receiving power by looking at the power LED. It should be illuminated and not flickering on and off.
7.0 SPECIFICATIONS Compliance HDMI 1.4 compliant with 3D, 4k x 2k support HDCP 1.
8.0 LIMITED WARRANTY If any Audio Authority product fails due to defects in materials or workmanship within one year from the date of the original sale to the end-user, Audio Authority guarantees that we will replace the defective product at no cost. Freight charges for the replacement unit will be paid by Audio Authority (Ground service only).
9.0 REGULATORY COMPLIANCE Model HBT200T and HBT200R have been tested for compliance with appropriate FCC and CE rules and regulations and are also RoHS compliant. The power adapters has been tested for compliance with UL, CE and CSA rules and regulations and is also RoHS compliant. 10.0 CONTACT INFORMATION Should you have questions or require assistance with this product in areas not covered by this manual, please contact Audio Authority using the information below.
2048 Mercer Road, Lexington, Kentucky 40511-1071 Phone: 859-233-4599 • Fax: 859-233-4510 Customer Toll-Free USA & Canada: 800-322-8346 Website: http://www.audioauthority.