Installation guide

10 of 34
3. To change the selected channel to a Custom single frequency
This option allows the customer to select 1 of over 1400 available channels.
Press and hold the “Jog-wheel” for approximately 3 seconds if the receiver is
not in mute to enter the MAIN MENU. You will enter the MAIN MENU
immediately if the receiver is in mute.
With FREQ SELECT underlined,
press the “Jog-wheel”. With SINGLE
underlined press the “Jog-wheel”.
With EDIT underlined press the “Jog-
wheel”. The first part of the frequency
will be flashing. Rotate the “Jog-
Wheel” to select this section of a new
frequency and press to accept. The
second part of the frequency will now
start flashing. Change the second part
of the new frequency as above. You
can then change each letter of the
user name in the same way. All ASCII characters are available for the user
name.
If you wish to exit this menu at any time, press and hold the “Jog-Wheel”.
Press the “Jog-Wheel” for 1 second to exit then rotate till ACCEPT is
underlined and press to select the new custom frequency and user name. Go
to the next step to program a transmitter via the receiver infra-red port.
Please note:
For S5.3 product the single user frequency will be added to the transmitter
with receiver Bank1. The S5.3 does not have USER bank.
In the case of the S5.5 it will be added to the Custom USER bank. You can
download USER banks via the Trantec software. Please refer to the software
manual on this CD for more information.
Units for the Japanese market do not have USER or SINGLE options in the
FREQUENCY SELECT menu.