User Manual Model HCX-11 HDMI Coax Extender TMDS R TMDS G TMDS B TMDS CLOCK INTERNAL POWER COAX OUTPUT TMDS R TMDS G TMDS B TMDS CLOCK INTERNAL POWER Five-Coax Extender • Model HCX-11 COAX INPUT 800-322-8346 • 859-233-4599 • www.audioauthority.com 12V DC POWER LINK HDMI INPUT Five-Coax Extender • Model HCX-11 800-322-8346 • 859-233-4599 • www.audioauthority.
WARNINGS • Read these instructions before installing or using this product. • To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture. • This product must be installed by qualified personnel. • Do not open the cover—there are no user-serviceable parts inside. • Do not expose this unit to excessive heat. • Install only in dry, indoor locations. • Clean the unit only with a dry or slightly dampened soft cloth.
Model HCX-11 HDMI Coax Extender Table Of Contents 1.0 Introduction . . . . . . . . . . . . . . . . . . . . . . . . 4 2.0 Getting the Best Results. . . . . . . . . . . . . . . . . . 4 3.0 Checking Package Contents . . . . . . . . . . . . . . . . 5 4.0 Installation . . . . . . . . . . . . . . . . . . . . . . . . . 6 5.0 Connecting the Hardware . . . . . . . . . . . . . . . . . 6 6.0 Troubleshooting . .
1.0 INTRODUCTION Thank you for purchasing this HDMI extender from Audio Authority. This transmitter/receiver unit is designed to extend HDMI version 1.3 signals to remote locations over five coaxial cables, with power for the receiver from the transmitter unit via the fifth cable. For long distances, a power supply may be connected to the receiver. The HCX-11 is capable of high-bandwidth formats including 1080p, 36* bit Deep Color, and lossless audio. The coaxial jacks accept secure, BNC type terminations.
extender system, and as a result, limits maximum cable run length. In general, use cable lengths 9 feet or less. There is one exception to this rule: if the system must pass only 24 bit signals the source may be connected to the HCX‑11 via an 18 foot HDMI cable. When transmitting 36 bit signals, both input and output HDMI connecting cables should be nine feet or less. See FEATURES for maximum coaxial cable lengths. Higher Resolution Refresh Rate Bit Depth • HDMI cables.
4.0 INSTALLATION • Before installing the HCX-11 Extender, connect the HDMI source directly to the display using a short, high quality HDMI cable. This precaution is to verify that the display is compatible with the source, and that the source is producing a resolution that the display can accept. • Using Internal Power Mode: The receiver may be powered through a fifth coaxial cable from the transmitter, with no power supply connected to the receiver.
12V DC POWER LINK HDMI INPUT HDMI LINK INDICATOR HCX-11 Transmitter HDMI INPUT POWER (REQUIRED) CLOCK SIGNALS (REQUIRED) TMDS G TMDS B TMDS CLOCK INTERNAL POWER COAX OUTPUT TMDS R TMDS G TMDS B TMDS CLOCK HCX-11 Transmitter TMDS COLOR CHANNELS (REQUIRED) TMDS R FOR INTERNAL POWER APPLICATIONS INTERNAL POWER • Connect the coaxial cables from the transmitter’s coax outputs to the receiver’s COAX coax inputs. Be careful to connect each cable toINPUT the correct jack.
• Connect the receiver’s HDMI output to the display using a short, high quality cable no longer than nine feet for 24 bit and 36 bit signals (see pages 4 and 5). • Plug in the provided AC adapter(s): first to the HCX-11 transmitter (and receiver, if external power is used), and then to active AC power outlet(s). • It is recommended to apply power in this sequence: HCX-11 Transmitter and receiver, then the HDMI source, then the video display. The HDMI LINK indicator confirms video is being transmitted. 6.
7.0 SPECIFICATIONS Tx-HDMI Input HDMI connector Rx-HDMI Output HDMI connector Tx – RG-6 output (5) via BNC Rx – RG-6 input (5) via BNC Video Connector Usage HDMI video/audio/clock via (4) RG-6 or RG-59 cables Internal Power Transmission 12VDC via (1) coax cable (up to 150 ft distance) Compliance HDMI v1.3, HDCP 1.1, DVI 1.1 Data Rate 2.
8.0 LIMITED WARRANTY If this Audio Authority product fails due to defects in materials or workmanship within one year from the date of the original sale to the end-user, Audio Authority guarantees that we will replace the defective product at no cost. Freight charges for the replacement unit will be paid by Audio Authority (ground service only).
9.0 REGULATORY COMPLIANCE The HCX-11 has been tested for compliance with CE and FCC rules and regulations. The power supplies included have been tested for compliance with UL, CUL, CE, PSE, and GS regulations and guidelines. This product and its power supplies are RoHS compliant. 10.0 CONTACT INFORMATION If you have questions or require assistance with this product in areas not covered by this manual, please contact Audio Authority using the information below.
2048 Mercer Road, Lexington, Kentucky 40511-1071 USA Phone: 859-233-4599 • Fax: 859-233-4510 Customer Toll-Free USA & Canada: 800-322-8346 www.audioauthority.com • sales@audioauthority.