USER MANUAL

AccuBASS® Level control
AccuBASS®
Threshold control
3. If you hear a spot where the bass just drops right out…stop.
Leave the volume there and go to your LC2i.
4. Set the AccuBASS® Level control on the top of LC2i to the
center detent.
5. Now, use a small screwdriver to turn the Threshold control
clockwise slowly until you hear the bass pop back in.
6. Re-adjust the AccuBASS® Level control on the top of the unit
to get the proper amount of bass compensation, and you’re
ready for some ground pounding bass. OK, what if your bass
doesn’t roll o, but you still want more?
No problem! Turn the AccuBASS® Level control fully down,
rotate the threshold control fully clockwise to lock in the bass
equalization. Now you can turn up the AccuBASS® Level con
-
trol for the amount of bass you want.
Level Matching:
For a video on Level Matching go to:
https://youtu.be/fmR2VrXHfbg or scan the
code at the left.
GTO™ Selector
GTO™ Great Turn On: No need to look for a trigger wire.
However you still need power and ground.
Connect the speaker level inputs and as soon as you turn on
the factory audio system the LC2i will power up as well. After
the LC2i turns on, it provides a 12 volt trigger output to turn
on your amplier. A Jumper which you can reach from the
end panel allows you to set this feature on/o for specialized
installations. The factory default setting for the GTO™ circuit is
always ON.
Setting the AccuBASS® Bass Compensation:
Factory speaker systems have trouble reproducing loud
clean bass. Some companies systems limit the bass at higher
volumes so as not to damage speakers. The AccuBASS® circuit
puts that bass back.
Here’s how you set it up. After the LC2i /Amps/ and speakers
are installed and ready go:
1. Turn the system on and play some music with a good bass
track.
2. Turn the volume up while listening for the bass.
®
TWO CHANNEL LINE OUTPUT
CONVERTER WITH ACCUBASS