Owner`s manual

SE3500D

INTERCONNECTION MASTER

• Connect the RCA lineouts of the headunit with the RCA jacks LINE INPUT of the amplifier with appropriate high-value RCA cables.

If your headunit is equipped with a additional subwoofer lineout (SUB OUT), it is recommended to use this lineout.

• Connect the remote wire (REM) to the remote terminal (REM) of the MASTER amp.

• Connect the bass remote wire only on the REMOTE port of the MASTER amp.

INTERCONNECTION SLAVE

• Connect the RCA jacks SLAVE IN/OUT of the MASTER amp with the RCA jacks SLAVE IN/OUT of the SLAVE amp with appropriate

high-value RCA cables.

• Connect the remote wire (REM) of the remote terminal (REM) of the MASTER amp with the remote terminal (REM) of the SLAVE amp.

Use therefore cable with a minimum profile section of 0,5 mm

• Connect the PROTECT BRIDGE port of the MASTER amp with the PROTECT BRIDGE port of the SLAVE amp with the enclosed

PROTECT BRIDGE wire.

INTERCONNECTION SUBWOOFER

• Check page 22.

SETTINGS MASTER

• The MODE switch should be in MASTER position.

Check the information LOW PASS, SUB SONIC, PHASE, LEVEL, SUB BOOST, FREQ RANGE, Q-CONTROL and BASS REMOTE

on page 20.

SETTINGS SLAVE

• The MODE switch must be in SLAVE position.

In the SLAVE mode all controllers of the SLAVE amp are without function.

Only the already modified audiosignal of the MASTER amp will be amplified.

INTERCONNECTION EXAMPLE Master/Slave Mode

1. Connect Stereo RCA output (L/R

or SUB OUT) of the headunit with the

LINE INPUT CH1/2 of the MASTER amp

Connect the bass remote

controller and the remote terminal

at the amplifier (MASTER)

with the enclosed cable.

Switch setting = MASTER

SLAVE

MASTER

Switch setting = SLAVE

Remote wire REM Remote wire REM

Protect Bridge wire

Remote wire REM

2. Connect Stereo RCA output (SLAVE IN/OUT)

of the MASTER amp with the SLAVE IN/OUT

of the SLAVE amp

The Master/Slave-Mode is only possible with two identical SE3500D amplifiers.

NOTE!