Owner's manual

Monitor 2 output functions in a similar way to monitor 1 except when a channel PFL

(pre-fader listen) switch is selected. In this case logic changes monitor 2 to read the

appropriate channel – mono PFL from a mic/line module and stereo PFL from a

stereo-line module. When PFL is released, monitor 2 reverts to signals derived using

monitor 2 select functions. PFL has a separate level control (36) to balance the signal

against other signals presented to monitor 2 outputs.

Main outputs A to D and L.R may be auditioned on left and/or right monitor 2 output,

using function switches (12) to (16). Selection of A, B, C or D presents a mono signal

of the selected output to monitor 2 output. A stereo signal of A and B can be achieved

by selecting both A and B. A will be presented to left monitor 2 output and B to right. A

stereo image of C and D can be auditioned by selection of C and D. Selection of L.R

(16) presents the left and right master outputs to monitor 2 left and right outputs

accordingly.

Main auxiliary outputs may be auditioned on monitor 2 output by use of rotary switch

(17), marked DIRECT. Position one of this switch routes signals to monitor 2 output

determined by the selection (12) to (16). Position six of the DIRECT rotary switch

(MON 1) routes monitor 1 output signals to monitor 2.

Monitoring of return signals is achieved using rotary switch (35) in conjunction with the

direct-return, push switch D/R (18). Selection of D/R routes the appropriately selected

return signals to monitor 2 output as follows:

RIL - Return 1 left signal to monitor 2 left & right

RIR - Return 1 right signal to monitor 2 left & right

RIS - Return 1 left signal to monitor 2 left output

and return 1 right signal to monitor 2 right output

R2L - Return 2 left signal to monitor 2 left & right

R2R - Return 2 right signal to monitor 2 left & right

R2S - Return 2 left signal to monitor 2 left output

and return 2 right signal to monitor 2 right output

DEC (19) introduces a matrix amplifier into the monitor 2 path. See M-S NOTES for

further information.

MONO (20) mixes a monitor 2 stereo output to mono and presents the mono signal to

the left and right outputs of monitor 2.

Monitor 2 output level control (21) is calibrated at the fully clockwise position of its

rotation.

For any L-R signal appearing on the monitor module, DEC (11) and (19) will reveal

mono compatibility (M) on monitor left, and out-of-phase components (S) on monitor

right.