Instruction Manual

This module controls the level of main and monitor output signals and metering of the

output and monitor signals (including PFL). Calibration is achieved when the output

faders (7) are at maximum.

The two LCD meters read the various outputs and battery status. The upper meter (1)

reads left and right outputs; the upper bar reading left output and the lower right

output. The lower meter (2) reads the auxiliary outputs, channel output and battery

status. The upper bar reads auxiliary 1 output, the middle bar auxiliary 2 output and

the lower bar the channel signal level at the pre-fader point. This is activated when

PFL is selected on an input module. Battery status is read on the six segment bar in

the lower left corner. Beginning with the sixth bar, each bar goes out in turn as the

battery level falls.

When the internal or external voltage drops below a safe operating level, the first

segment of the battery level indicator will flash. Meters may be illuminated by ILL (8).

If a greater level of back-light is required then a facility exists on each meter, via a DIL

switch, to achieve this. A second DIL switch changes the meter specification between

PPM and VU. Refer ADJUSTMENTS & CALIBRATION section.

The main output signal is metered and monitored after the output faders and limiters.

A pair of limiters may be switched in to the main output - LIM (12) - and linked for

stereo operation - LINK (9). LEDs (10) indicate when limiting is taking place. A choice

of fast or slow attack and release times may be made via the two DIL switches on the

output printed circuit board. When the limiters are being used as a stereo pair, they

should have their attack times and release times set identically. The factory setting for

the DIL switches is SLOW.

OUTPUT MODULE PRINTED CIRCUIT BOARD