User's Manual

- 15 -
A10-RX User Guide
3. Load the ALUG le into Mic2Wav.
4. Select Send to RX. Mic2Wav will detect and display the connected receiver.
5. Select the Send check box and click Send.
To send a user group to A10-RX-SL receivers via A10-RACK:
1. Start the Mic2Wav application.
2. Connect the A10-RACK to the computer’s USB port.
3. Load the ALUG le into Mic2Wav.
4. Select Send to RX. Mic2Wav will detect and display all A10-RX receivers installed in the
A10-RACK.
5. Select the check boxes next to each receiver to which you want to send the User Group.
6. Click Send.
To send a user group to A10-RX-SL receivers via 688/SL-6:
1. Using an SD card already formatted in a 688, save the ALUG le to a formatted SD card.
2. Insert the SD card into the 688.
3. With the A10-RX-SL receiver(s) in the SL-6 slots, power on the 688/SL-6.
4. Access the Receiver Overview screen by doing either of the following:
• HP + METERS: Press and hold the Headphone encoder, then press the METERS button.
• Press MENU, then use the Headphone encoder to select SL-6 > Receiver Overview.
5. Select a channel.
6. Slide RTN/FAV switch right to select Menu.
7. Select User Groups > User > Load New.
8. Select a user group from the ALUG le.
While the SD card can have multiple ALUG les, each with up to eight groups, only one user
group at a time may be loaded to a receiver.
A10-RX receivers can operate in one of two modes: User and Factory. In Factory mode,
frequencies are manually dialed in, but in User mode (when a user group is loaded), pre-set
frequencies are dialed in by user name.
To set the receiver to User mode:
1. Press the Centre Menu button on the receiver.
2. Select Settings > User Groups > User.