User's Manual

- 17 -
A10-RX User Guide
A10-RX-SL
Updating the rmware on the A10-RX-SL may be done via the Sound Devices 688, while the
receiver is slotted into the SL-6 powering and wireless accessory.
To update rmware on an A10-RX-SL:
1. Download new rmware update le from the Audio Ltd. website.
2. Power on the 688 and SL-6
3. Insert the SD card into the slot on the side of the 688.
4. METERS + HP: Press the METERS button, then push in the Headphone encoder to
access Receiver Overview screen.
5. Turn and press the Headphone encoder to select a receiver. This accesses the Receiver
Details screen.
ª You need only select either channel per receiver to perform the update for the entire receiver.
6. Slide RTN/FAV switch to select Menu.
7. Use Headphone encoder to select Update Firmware. The 688 will prompt you to conrm
a search of inserted CF/SD cards for a programming le (PRG). Select OK to continue.
8. After it nds a le, the 688 will prompt you to conrm it has found the correct le. If it is,
select OK to continue.
ª As the receiver is updated, its screen will display Programming and the LEDs will turn off.
This is normal operation.
9. Repeat steps for each receiver in the SL-6.
Updating RX from A10-RACK
Updating rmware on A10-RX wireless receivers may be done when they are slotted into the
A10-RACK. This does require connection to a computer, running the latest version of Mic2Wav,
which is available as a free download from the Audio Ltd. website.
Prior to updating A10-RX-SL receivers installed in the A10-RACK, ensure the following:
• Receivers are properly slotted into the A10-RACK, the A10-RACK is connected from the
USB-B port on the back panel to a USB-A port on the computer, and that it is powered ON.
• Download and install on the computer the latest version of the Mic2Wav utility from Audio
Limited’s website at: https://audioltd.com/resources/mic2wav/
• Download to the computer a new rmware update le (PRG) from the Audio Limited’s
website, specically the Resources > Firmware Downloads webpage.
ª A Change List of new features for the latest rmware can also be found on this webpage.
To update rmware on A10-RX-SL receivers via connection to the A10-RACK:
1. Start the Mic2Wav utility application.
2. Click File > Update RX and then select the rmware update le (PRG) previously
downloaded to your computer from the Audio Limited website.
3. After a momentary refresh, Mic2Wav will detect all A10-RX-SL receivers in the A10 RACK.
Mic2Wav will display the A10 Receivers listed in order and display the Serial Number as
well as current Firmware Version.