User's Manual

- 6 -
A10-RX User Guide
Powering
The A10-RX-SL receives power over its D-sub connector. The A10-RX-XLR receives power
from its 4-pin Hirose female connector. The male Hirose connector is a power loop through.
When DC power is present, either at the D-sub connector or the Hirose 4-pin, the A10-RX is
powered. There are no additional power switches.
Channel Powering
Each of the two channels of the A10-RX can be powered on or off individually. When a channel
is powered down that portion of the A10-RX no longer draws power. If the A10-RX is going to
be used for a single wireless channel, best practice is to power down the unused channel.
Channel powering is controlled in the Selection Menu (Main > System > Power).
ª Shortcut: To power off RX1, simultaneously hold the Left and Centre Menu buttons down for
two seconds. To power off RX2, simultaneously hold both Right and Centre Menu buttons
down for two seconds. Repeat to turn the individual channels back on. If both RX channels
are powered off, the A10-RX will enter standby mode. Press the Centre button to turn both
channels of the RX back on simultaneously.
Channel Power LEDs
The A10-RX has blue Channel Power LEDs for each of its two channels. When rst powering
the A10-RX without transmitters present, the LEDs illuminate indicating the receiver channel is
powered.
The receiver channel will connect, or pair, to an A10-TX transmitter that is powered on and set
to the receiver frequency. The Channel Power LED then shows the battery status of its associated
transmitter.
• Solid Blue - a solid blue LED indicates that the transmitter battery is in good condition.
• Flashing Blue - a ashing blue LED indicates when the transmitter battery level is low or
depleted.
When a paired transmitter is powered down, the blue LED continues to show the last condition
of the transmitter battery. If the transmitter is powered back on, or a new transmitter is activated
on the channel, that transmitter pairs with the receiver and its transmitter battery condition is
shown with the blue LED.
ª The LEDs change assignment based on the orientation of the display. Channel 1 is always
shown left of the display and channel 2 is always on the right.