User Manual

KeySwitches

Depending on the “KS Octave” parameter, Key Switches can be positioned beginning at            

any octave from C-1 to C2, or they can be disabled.

By default, the Key Switches are positioned starting from C1 (MIDI note 24)where C3 =              

Middle C (MIDI note 60). You can change the MIDI channel from which Key Switches              

receive note-events through the “KS Channel” setting. This can be useful when controlling            

Key Switches from a separate keyboard.

The Key Switch state depends on the note-on velocity. The velocity curve can be adjusted              

using the “KS Velocity Remap” parameter.



The Key Switches provided are:

● C = Pipe Gesture, depending on the selected Pipe Model at the next note-on:





Valves



Low Velocity = Norm Valve (overtones transitions).

Mid Velocity = Half Valve Transitions.

High Velocity = Half Valve.



Slide



Low Velocity = Fixed Slide (overtones transitions).

Mid Velocity = Slide Follow Real (bend).

High Velocity = Slide Follow +/-7 (extended).



● C# = Fall Down. Perform an immediate Fall Down starting from the currently playing

note (where the pitch and volume drop rapidly):

○ Velocity controls Fall Down speed.

● D = Doit. Perform an immediate Doit starting from the currently played note (where

the pitch rises rapidly and the volume decays):

○ Velocity controls Doit speed.

● D# = Legato Priority (at next note-on):

○ Low Velocity = OFF.

○ High Velocity = ON.



All parameters controlled by the Key Switches can be controlled by MIDI Control Change,

After Touch and NRPN messages as well through the Controller Mapping section.

 



SWAM Solo Brass - v1.0.1



34

