CDT Zero/II CD TRANSPORT OWNER’S INFORMATION
! IMPORTANT SAFETY INFORMATION ! HUMIDITY: DO NOT STORE OR OPERATE THIS UNIT IN AREAS OF HIGH HUMIDITY, OR IN CLOSE PROXIMITY TO WATER/DAMPINESS. DO NOT EXPOSE THE UNIT TO LIQUID. EARTHING: THIS PRODUCT MUST BE EARTHED – ENSURE THAT THE MAINS SUPPLY CABLE IS EARTHED. SHOCK: INTERNAL OPERATING VOLTAGES ARE LETHAL! DO NOT REMOVE THE TOP COVER. DO NOT ATTEMPT TO REPLACE THE FUSE WITHOUT DISCONNECTING THE UNIT FROM THE MAINS SUPPLY.
CLASS 1 LASER PRODUCT This product contains a low power laser device. To ensure continued safety, do not remove any covers or attempt to gain access to the inside of the product. Refer servicing to qualified personnel. Make Your Contribution to Protect the Environment Used batteries with the ISO symbol for recycling, as well as small accumulators (rechargeable batteries), mini-batteries (cells) and starter batteries should not be thrown into the dustbin. Please leave them at an appropriate depot.
GENERAL Congratulations on your purchase of the Audio Note CDT Zero/II CD Transport. Audio Note is highly critical of the digital medium as presented by compact disc; we sincerely hope that you too will find this transport breaks free from the 'digital mould' that we are all so accustomed to, and so open a new window on your CD collection. Please read over this manual carefully in order to obtain the best possible performance and longevity from your transport.
LOADING THE DISC • Turn the power on. • Press the OPEN/CLOSE button and load a disc on the tray Be sure to load a disc with the tray fully opened. The label side of a disc should be facing upwards with the disc correctly seated in the tray. • Press the OPEN/CLOSE button again. The disc tray will close. Within a few seconds, the number of tracks and the total playing time of the disc will appear on the display. • Press the OPEN/CLOSE button to unload a disc.
VIA REMOTE CONTROL (batteries are not included) Batteries suitable for the CDT Zero/II remote control are two of 1.5V UM-3/R6/AA type and are not included. They should be bought separately and fitted into the remote control before operating it. Please ensure that the batteries are inserted correctly and polarity is right. OPEN/CLOSE - Operates in the same way as the front panel button. Press this button to open or close the CD tray. PLAY/PAUSE ►▐▐ - Press this button to play a disc.
TIME button. Press this button to see the elapsing or remaining time of the CD. (Play mode only.) Press the TIME button and select the desired TIME DISPLAY for CD playback. Each time this button is pressed, selection is as follows: "EACH REMAIN" "TOTAL" "TOTAL REMAIN" the elapsed playing time for the current track. the total elapsed playing time. the remaining playing time for the current track. REPEAT button. Press this button to listen to the music repeatedly. First press to repeat the entire disc.
TROUBLESHOOTING GUIDE Refer to the relevant sections in the manual for remedy suggestions. SYMPTOM No sound from the CD player. CHECK POINT CD is not selected on the amplifier. Playback does not start. The disc is dirty. The disc is upside down. The player is in the PAUSE mode. Moisture condensation has caused the unit to operate incorrectly. "NO DISC" appears. There is no disc loaded or the disc is loaded incorrectly. Playback does not start from the first track.
