User Manual
Table Of Contents
4
Electronic audio components have a running in period of around
a week (if used several hours per day). This will allow the new
components to settle down and the sonic properties will improve
over this time.
POWER SOURCES
The unit should be operated only from the type of power source
indicated on the marking label. If you are not sure of the type of
power-supply to your home, consult your product dealer or local
power company.
If you do not intend to use this unit for a long period of time, unplug
it from the mains socket.
OVERLOADING
Do not overload wall outlets or extension cords as this can result in a
risk of re or electric shock. Overloaded AC outlets, extension cords,
frayed power cords, damaged or cracked wire insulation and broken
plugs are dangerous. They may result in a shock or re hazard.
Be sure to insert each power cord securely. To prevent hum and
noise, do not bundle the interconnect leads with the power cord or
speaker leads.
CLEANING
To clean the unit, wipe its case with a dry, lint-free cloth. Do not use
any cleaning uids containing alcohol, ammonia or abrasives. Do
not spray an aerosol at or near the unit.
BATTERY DISPOSAL
Batteries may contain substances harmful to the environment.
Please dispose of any discharged batteries with due consideration
and in accordance with local environmental/electronic recycling
guidelines.
SERVICING
These units are not user serviceable. Never attempt to repair,
disassemble or reconstruct the unit if there seems to be a problem.
A serious electric shock could result if this precautionary measure
is ignored. In the event of a problem or failure, please contact your
dealer.
WEEE SYMBOL
The crossed-out wheeled bin is the European Union symbol
for indicating separate collection for electrical and electronic
equipment. This product contains electrical and electronic
equipment which should be reused, recycled or recovered and
should not be disposed of with unsorted regular waste. Please return
the unit or contact the authorised dealer from whom you purchased
this product for more information.
CE MARK
This product complies with European Low Voltage
(2014/35/EU), Electromagnetic Compatibility (2014/30/EU) and
Environmentally-friendly design of Energy-related Products
(2009/125/EC) Directives when used and installed according to this
instruction manual. For continued compliance only Cambridge
Audio accessories should be used with this product and servicing
must be referred to qualied service personnel.
RCM (REGULATORY COMPLIANCE MARK)
This product meets Australia, New Zealand Safety, EMC and
Radio Communications requirements of the ERAC and ACMA.
CU-TR MARK
This product meets Russia, Byelorussia and Kazakhstan
electronic safety approvals.
Caution: Hot Surface. Do Not Touch
The both side heat sinks of the product may become hot
when operating this product continuously. Do not touch
hot areas.
Note: Due to the surface of both heat sinks are not suitable to stick
the label there is none sticker on the product
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
FEDERAL COMMUNICATIONS COMMISSION
NOTICE
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try and correct the
interference by one or more of the following measures: