User manual

The first microphone MIC1 is prior to all others. MIC1 being in use automatically gates all other microphones.
If music is hooked up to the system while an announcement is being made, the gate shuts of the music so
that with the specific desktop microphone the announcement signal can go through.
This setting will remain untill the announcement is ended.
Automatically then the music fades back in.
For the use of dynamic handheld microphones it is not necessary to set back the jumper postion. Because of
its dynamic character this type of microphone does not need phantom cicuit/power.
Desktop microphones - priorities
ports for desktop microphones (MIC1 and MIC2, XLR ports)
Priorities
The MX-AMP 60 and MX-AMP 120 allows you additionally to deactivate the mute control. This can be done
by a slide switch inside the device.
The slide switch is placed directly behind the front panel at the upper edge.
The MX-AMP 60 and MX-AMP 120 is being delivered with the slide switch set "off" by default.
In order to activate the mute control the slide switch must be set "on”.
slideswitch inside the device behind the front panel
ON
OFF
Device Functions
- Rear side/inside -
ic audio
19
EN
DC
24
V
G
ND
O
PRI R
IT
Y
+
-
I
PUTN
C
H M
E
I
CHIME
ON OFF