Owner`s manual

ManualsBrandsAudio Pro Manualsaudio & home theatreLIVING LV33

The MX136 has twelve Analog Audio Inputs numbered 0

through 11, six Digital Audio Inputs lettered A through F

and five Component Video Inputs numbered 1 through 5.

There are also four HDMI (Digital Video) Inputs numbered

1 through 4. These inputs already have assigned titles and

associations that will allow for immediate hookup, opera-

tion and enjoyment.

If these starting assignments and associations do not match

up with components in your system, they may be reassigned

from the default settings. The following example will illus-

trate how to rename the TAPE2 Input to DVD2 and assign

it the LV Digital Input. When the Zone A or B Input Selec-

tor is rotated to select what was originally the TAPE2 Input,

DVD2 will now appear on the Front Panel Alphanumeric

Display. The Surround Mode, Video Power Control, HDMI

Video and Component Video can also be set for each Input.

Notes: 1. The very first time the INPUT SETUP is accessed,

the default settings will be indicated.

2. Unused Inputs may be switched Off so that they will

not appear when rotating through the input source

choices using the Zone A or Zone B Input Selector

and also will not be available when using the Remote

Control or Keypad.

1. Press and hold the Front Panel SETUP Push-button ap-

proximately three seconds to enter the Setup Mode. The

word SETUP will appear on the MX136 Front Panel

Display and the MAIN SYSTEM SETUP Menu will

appear on the Monitor/TV screen. Refer to figure 6 on

page 26.

2. Using the Up or Down directional push-buttons on

the Remote Control, select INPUT SETUP on the On-

Screen Menu, followed by the SELECT/OK Push-but-

ton. Refer to figure 6 on page 26.

3. Using the Up or Down directional push-buttons,

select SOURCE INPUT from the On-Screen Menu, fol-

lowed by pressing the Left or Right directional

push-buttons to select Input Number 5 - IR-TP2. Refer

to figure 15.

Note: The information displayed after the Source Input

Number indicates which IR Remote Control

Command selects the input.

Analog Audio/Video Input Title

4. Using the Up or Down directional push-buttons,

select TITLE, followed by pressing the SELECT/OK

Push-button. The On-Screen Menu Title can now be

changed from the default name. Refer to figure 16.

5. Using the Up or Down directional push-buttons,

select “D” as the first character of the new title.

Note: The TITLE may be up to 4 characters in length

including (0 thru 9) and (A thru Z).

How to Change the Input Setup

6. Press the Right directional push-button to select the

second character position of the title.

7. Using the Up or Down directional push-buttons to

select “V” the second character of the title.

8. Select the two remaining characters “D” and “2” of the

title by using the directional push-buttons.

9. Press the SELECT/OK Push-button once and then

press the Down directional push-button.

10. Proceed to the Digital Input Setting. If you do not wish

to perform Digital Input Setting at this time, proceed

to the ZONE A Analog Input Setting.

SETUP, con’t

MENU: INPUT SETUP

ÆSOURCE INPUT 5 - IR-TP2

TITLE TAPE2

DIGITAL INPUT NONE

ZONE A ANALOG INPUT RCA

SURR MODE LAST

VIDEO POWER ON

HDMI VIDEO NONE

COMPONENT VIDEO NONE

MAIN MENU

Figure 15

Figure 16