Owner`s manual
Limited Warranty
Audio  Research  Corporation  products  are  covered by  a 3-
Year Limited  Warranty,  or  a  90-Day Limited Warranty 
on vacuum tubes. This Limited Warranty initiates from the
date of purchase, and is limited to the original purchaser, or
in  the  case  of  demonstration equipment, limited  to the 
balance  of warranty  remaining after original  shipment  to
the retailer or importer.
In  the United States,  the  specific terms,  conditions  and
remedies for fulfillment of this Limited Warranty are listed
on the warranty card accompanying the product in its ship-
ping carton, or may be obtained from the authorized retail-
er  or  from  the  Audio  Research  Customer  Service  Depart-
ment. Outside the United States, the authorized importing
retailer  or  distributor  has  accepted  the  responsibility 
for  warranty of Audio Research products sold by them. 
The specific terms  and  remedies  for  fulfillment  of  the 
Limited Warranty  may  vary  from  country  to  country. 
Warranty  service  should  normally  be obtained  from  the 
importing retailer  or  distributor from  whom  the product
was purchased.
In the unlikely event that technical service beyond the abil-
ity  of the  importer is  required, Audio  Research  will  fulfill
the terms  and conditions  of  the  Limited  Warranty.  Such
product must be returned at the purchaser's expense to the
Audio  Research  factory,  along  with a  photocopy  of  the 
dated  purchase  receipt  for  the product,  a written descrip-
tion  of the  problem(s) encountered,  and  any  information
necessary for return shipment. The cost of return shipment
is the responsibility of the purchaser.
Specifications
OUTPUTS, ANALOG: (Stereo)
1. Balanced XLR 5.4V RMS (+14.6dBv) max.
2. Single-Ended RCA 2.7V RMS (+8.6dBv) max.
OUTPUT IMPEDANCE: (Analog)
660 ohms BAL, 330 ohms SE.
FREQUENCY RESPONSE:
0.5–20,000Hz + 0 -1dB.
SIGNAL TO NOISE RATIO: 110dBA
DISTORTION: .005% 1kHz
RESOLUTION: 24 BIT DELTA-SIGMA DAC.
CHANNEL SEPARATION: 95dB 1kHz.
OUTPUTS, DIGITAL: (to external Digital-to-Analog Converter)
1. XLR Balanced AES/EBU 110-ohm 4V P-P.
2. BNC coax SPDIF 75-ohm 0.7V P-P.
SIGNAL FORMAT (disc):
Sampling frequency: 44.1kHz.
Quantization Bit: 16bit linear per channel.
Channel bit rate: 4.3218Mb/sec.
Channel modulation code: EFM (8 –14 modulation).
Error correction: CIRC (cross interleave Reed 
Solomon Code). 
DRIVE MECHANISM (top load):
Wow & Flutter: Unmeasureable (Quartz stability).
Discs: Accepts 5" (12cm) and 3" (8cm) sizes. 
OPTICAL PICKUP:
Type: 3-beam LDGU (Laser Diode & Grating Unit), with 
holographic diffraction light pen.
Laser: GaAIAs semiconductor, 780nm, 0.5mW maximum 
output.
Servo: Digitally-controlled low-inertia linear positioning 
actuator.
JITTER REDUCTION: High-stabillity crystal-controlled 
re-clocking for all outputs.
DISPLAY: Six-digit vacuum fluorescent, with optical filter.
POWER REQUIREMENTS (detachable power cord):
5
Model Reference CD7










