Manualshelf

User Manual

ManualsBrandsAudio-Technica Consumer ManualsBluetooth HeadphonesATH-ANC500BT QuietPoint Wireless Over-Ear Noise-Canceling Headphones
12345678910
7
Connecting via Bluetooth
To connect the product to a Bluetooth device, the product needs to pair (register) with the device.
Pairing a Bluetooth device
• Read the user manual for the Bluetooth device.
• Place the Bluetooth device within 1 m (3.3') of the product to perform pairing correctly.
• To confirm the progress of the pairing process, wear the product while performing this procedure and listen for the
confirmation tone.
1. Starting with the product turned o, turn it on.
• The multi-indicator lamp will alternately flash in red and blue.
2. Use your Bluetooth device to begin the pairing process and search for the product.
When your Bluetooth device finds the product, “ATH-ANC500BT” will be displayed on the device.
• For information about using your Bluetooth device, refer to the device’s user
manual.
3. Select “ATH-ANC500BT” to pair the product and your Bluetooth device.
• Some devices may ask for a passkey. In this case, enter “0000”. The passkey
may also be called a passcode, PIN code, PIN number, or password.
• The product sounds a confirmation tone when pairing is complete.
About pairing
When connecting a new Bluetooth device, you need to pair it with the product. Once the Bluetooth device and the product
are paired, you do not need to pair them again. The product supports multipairing, in which a connection history is saved.
However, in the following cases you will need to pair again even if the Bluetooth device was paired once:
• If the product is deleted from the Bluetooth device’s connection history.
• If the product is sent out for repair.
• When switching to a Bluetooth device, you may not be able to
pair because the previously connected Bluetooth device cannot
be disconnected. In such cases, press and hold (about 4 seconds)
the multifunction button and volume “–” button at the same time
as shown in the figure. The product will switch to the “searching
for devices” state and you will be able to pair with your desired
Bluetooth device.
Volume “–” button
Multifunction button
100%12:00
Bluetooth ON
ATH-ANC500BT